Kurtz Ersa Wave Solder
ERSA POWERFLOW · Nitrogen wave soldering · downstream of ST5 camera inspection
Standby
Pot temperature
255.0°C
Setpoint 255 °C ±6
Preheat
110°C
Setpoint 110 °C
Conveyor speed
0mm/min
Setpoint 1200 mm/min
Nitrogen blanket
48ppm O₂
Below 100 ppm keeps dross down
Flux density
0.830g/cm³
Checked every 8 h against the bath
Boards soldered
0bd
9.5 kW draw now
Machine schematic
Fluxer → preheat → nitrogen wave → cooling
Machine detail
Make / modelKurtz Ersa ERSA POWERFLOW
ProcessNitrogen wave soldering
Nominal dwell145 s
Board in machineNone
Machine stateStandby
Electrical draw9.5 kW
Boards inspected upstream0 (0 diverted)
Rejected boards are pulled at ST5 and never enter the machine, so the soldered count trails the inspected count by the reject total.
Process window
Actual against the saved setpoints
| Process value | Actual | Setpoint | Deviation | Tolerance | Drift | Status |
|---|---|---|---|---|---|---|
| Solder pot temperature | 255.0°C | 255°C | +0.0 | ±6 | IN WINDOW | |
| Preheat temperature | 110.0°C | 110°C | +0.0 | ±12 | IN WINDOW | |
| Conveyor speed | 0.0mm/min | 0mm/min | +0.0 | ±40 | IN WINDOW |
Setpoints are edited on the Settings page and stored with the line configuration; a pot temperature outside the window raises alarm WS-101.
Machine alarms
Wave solder and quality codes
No alarms — line nominal.